: Lutron Grafik Eye GRX-CI-RS Control Interface V Class 2: Camera & Photo. Find great deals for Lutron Grafik Eye Grx-ci-rs Control Interface. Shop with confidence on eBay!. Grafik Eye, Control Interface, Uses RS Command Set for Grafik Eye / , Low-Voltage 12 – 24VDC, Wall Mounting.
|Published (Last):||26 September 2017|
|PDF File Size:||9.84 Mb|
|ePub File Size:||12.72 Mb|
|Price:||Free* [*Free Regsitration Required]|
Adjust scenes to reflect status of movable walls. Please be advised, all buyers and sellers should satisfy themselves that the other party is genuine by providing the following via private conversation to each other after negotiations are complete and prior to dispatching goods and making payment: Does not cause lights to flicker or interact anywhere in dimming range.
These codes allow additional features including:. Module protects itself grx-ci-rd232 most temporary over-current and over-voltage conditions. Selects Scene 16 full ON. Standards UL listed Power Load output power phase independent of lighting: Minimum load on power module is lurton W.
You must log in or sign up grx-ci-rs22 reply here. Power module is UL tested and approved for use in air plenums.
Lutron EA Ltd GRX-CI-RS : Interface, RS Grafik Eye
Operates these sources with a smooth continuous Square Law dimming curve or on a full conduction non-dim basis:. Using the inputs, contact closures in other equipment can operate control units to: Using the outputs, scene changes in control units can: Dissipates a maximum of 10 watts when the controlling dimmer is near high-end.
It’s in your best interest to check out these details yourself. Starts a sequence, loops continuously through scenes 5 to 16 using fade times entered at Control Units.
Carshalton, Surrey Advertised elsewhere?: Your nickname or email address: Allows control of V loads using a V lighting control. Not for use with non-dim loads.
Dec 2, at 6: Module protects itself during temporary over-current and over-voltage conditions. Models available for V control power. Models available for V or V load power. A test switch is provided to perform a functional test of the system by simulating an emergency situation.
Thanks for the offer but I couldn’t go that high.
Lutron, Grafik Eye, GRX-CI-PRG
To control these types of equipment, a flyback diode must be used DC voltages only. Not compatible with V, V, or V input power. This item has been used but is in full working order. Inductive loads include, but are not limited to, relays, solenoids, and motors. For scene selection and special function modes, one control unit or a group of control units may be assigned to be operated by grx-ci-rs2322 GRX-IO.
Incandescent and electronic low-voltage sources may be controlled on the same zone.
LUTRON – GRAFIK EYE CONTROL INTERFACE – 12-24V PELV CLASS 2
Phase independent of Control Unit. Use switching power module for non-dim loads. Switches and dims any V electronic fluorescent dimming ballast powered by V ballast must provide V source. Model available ltron V control power. Up to five Modules may be linked to obtain the necessary load capacity. Available in one, two, and three-circuit Dimming Modules. Dec 3, at 7: Accepts either V or V input power. Phase-adaptive technology automatically selects leading-edge or trailing-edge dimming for low-voltage transformers.
Yes, my password is: Models available for V only or V load voltage. Presents a simulated load to the dimmer to meet the minimum load requirements even when the actual load is smaller. Provides power and switching for one zone.
Open collector PNP or active-high on-state voltage must be greater than 12 V and source 3. Operating Modes Scene selection Special functions Partitioning Occupant sensor Five Input Terminals Accept maintained inputs and momentary inputs with 40 msec minimum pulse times. Tested to withstand 15 kV electrostatic discharge without damage or memory loss.